Loading...


Error load page? Click here to reload.

This is the Configuration tab on the Ublox device.

Hardware UART connect :
ESPrtk ZED-F9PM8POther Ublox Module
TX UART-1RX UART-1RX UART-1RX UART-config
RX UART-1TX UART-1TX UART-1TX UART-config
TX UART-2RX UART-2RX UART-config
RX UART-2TX UART-2TX UART-config

- First, start connecting to the module with a baudrate.
- Use "Autoscan Baudrate" to scan if dont know baudrate.
- Wait a moment after changing the baudrate.
- Do not click too quickly (after configure, you need wait a moment).
- Items marked with '*' are not supported yet.
- Scroll the Configure tab to see the full component.

The above is a short introduction, click here for detailed instructions on the device support website.