ESPrtk
High quality RTK positioning solution with low cost ESP32 . (2.7.6)
This is the Configuration tab on the Ublox device.
Hardware UART connect :| ESPrtk | ZED-F9P | M8P | Other Ublox Module |
|---|---|---|---|
| TX UART-1 | RX UART-1 | RX UART-1 | RX UART-config |
| RX UART-1 | TX UART-1 | TX UART-1 | TX UART-config |
| TX UART-2 | RX UART-2 | RX UART-config | |
| RX UART-2 | TX UART-2 | TX UART-config |
- First, start connecting to the module with a baudrate. - Use "Autoscan Baudrate" to scan if dont know baudrate. - Wait a moment after changing the baudrate. - Do not click too quickly (after configure, you need wait a moment). - Items marked with '*' are not supported yet. - Scroll the Configure tab to see the full component.
The above is a short introduction, click here for detailed instructions on the device support website.