This is the Configuration/Query tab on the Navspark device.Hardware UART connect :
|TX UART-1||RX1 UART||RX UART||RX UART-config|
|RX UART-1||TX1 UART||TX UART||TX UART-config|
|TX UART-2||RX2 UART||RX2 UART||RX UART-config|
|RX UART-2||TX2 UART||TX UART-config|
- First, start connecting to the module with a baudrate. - Wait a moment after changing the baudrate. - To check the response from moudle Navspark, you can send "Query Software Version". - Do not click too quickly (after configure, you need wait a moment). - Items marked with '*' are not supported yet. - Scroll the Query tab to see the full component.
The above is a short introduction, click here for detailed instructions on the device support website.